Commercial Aviation EMC Testing
Elite Electronic Engineering is a leader in providing EMC and environmental stress testing services to the commercial aviation industry. Our test and consulting engineers assist manufacturers of aircraft avionics, power generating equipment, and other flight support systems comply with rigorous governmental requirements and aircraft OEM specifications. Since Elite is highly regarded in the aviation industry, our test results and reports are readily accepted and approved by the major aircraft OEMs.
Commercial Aviation Test Expertise
- RTCA-DO 160 Revision F, E, D, C
- Boeing D6- 16050-4iNARTE Certified Engineers
- Elite's staff of EMC Engineers are iNARTE certified to assure you the highest caliber of expertise and service.
- ISO 17025 Accreditation for RTCA DO-160 Tests
- Combined Test Services of EMC and Environmental Stress Testing. Provides convenience and less cost to run EMC-ENV tests concurrently.
HIRF Testing
Elite’s powerful collection of amplifiers can deliver High Intensity. Radiated Field (HIRF) testing in excess of 200V/m throughout the range of 10kHz to 40GHz, and higher levels at other ranges.
RS103 High Field Radiated Susceptibility:
- 200V/m from 10kHz-40GHz
- 600V/m from 400MHz-1000MHz
- 1000V/m-1500V/m from 1GHz-18GHz (Pulsed RF) anechoic chamber
- 2000V/m-3000V/m in the mode tuned chamber
Section 22 Lightning Susceptibility
Elite has the expertise and equipment to apply DO-160 Section 22 Secondary Effects Lightning transients including single stroke (SS), multi-burst (MB), and multi-stroke (MS) pulses. Elite can apply all RTCA DO 160E waveforms at Level 5.
- Pin Injection: 3(1MHz)/4/5A/5B up to Level 5
- Cable Injection: SS & MS 1/2/3 (1&10 MHz)/4/5A/5B up to Level 5
- Cable Injection: MB 3(1&10 MHz) up to Level 5
Combined Test Services of EMC and Environmental Stress Testing. Convenience, less cost, run EMC-ENV tests in parallel
Special Utilities and Services
- Readily available 400Hz or 28VDC power
- Waveguide interface on RF test chambers for hydraulic and pneumatic hoses
- Compressed air: 90PSI, 150CFM, Refrigeration Dried; Cooling water: 30PSI, 7GPM
- Configurable resistive power load banks and heat exhaust capability
Test Reports and Test Plan Development
Elite technical documentation services include the development of formal test plans and test reports.
